Surr Setup Screen - Yamaha PM5D Owner's Manual

MATRIX/ST function

SURR SETUP screen

Here you can make various settings related to surround
functionality, such as selecting the surround mode, and
assigning MIX buses to surround channels.
SURR SETUP
A SURROUND MODE
Choose one of the follow-
ing as the surround mode
when using the Surround
Pan function (➥ p.132).
This is the same as the
SURROUND MODE in
the MIXER SETUP screen
(SYS/W.CLOCK func-
tion). The graphic below
the buttons will change
according to the mode you
select.
• STEREO
This is conventional stereo
mode.
• 3-1ch
This mode uses four chan-
nels: L (front left), C (front
center), R (front right),
and S (surround).
• 5.1ch
This mode uses six channels: L (front left), C (front
center), R (front right), Ls (rear left), Rs (rear right),
and LFE (subwoofer).
• 6.1ch
This mode uses seven channels: 5.1ch with the addi-
tion of Bs (rear center).
Hint
If 3-1ch, 5.1ch, or 6.1 ch is selected as the surround mode,
MIX buses 1–8 or 9–16 are used as surround buses, starting
with the earlier-numbered buses. (Buses not used as sur-
round buses can be used as conventional buses.) These MIX
buses cannot be used as conventional bus outputs until you
return to stereo mode.
244
PM5D/PM5D-RH Owner's Manual
1
Reference section
2
B Bus assignments
This area indicates the surround channels assigned to
the MIX buses that are being used as surround buses.
You can edit these settings by clicking the
tons at the left and right.
When you change the surround channel assignment,
the MIX bus whose channel assignment you changed
will be exchanged with the MIX bus that had been pre-
viously assigned to that channel.
Note
The MIX buses used are fixed for each surround mode.
For surround mode 3-1, MIX buses 1–4 or 9–13 can be used.
For surround mode 5.1, MIX buses 1–6 or 9–14 can be used.
For surround mode 6.1, MIX buses 1–7 or 9–15 can be used.
Other MIX buses can be used as conventional MIX buses.
However in the case of 6.1, MIX bus 8 or MIX bus 16 are
always handled as FIXED buses.
C INIT (Initialize)
For each surround mode, this restores the surround
channel assignments to the MIX buses to their initial
state.
D SURROUND BUS ALLOCATION
Select either MIX buses 1–8 or 9–16 as the range of
MIX buses used as surround buses.
3 4
/ but-