Added Support For Remote Operation Of R Series Devices (Dante Supported I/O Rack) (Nuage Fader); Added Quick Control Setting Screen (Nuage Master) - Yamaha NUAGE FADER Ncs500-FD Operation Manual

Added support for remote
operation of R series devices
(Dante supported I/O rack)
(Nuage Fader)
The HA gain of R series devices (Rio3224-D, Ri8-D, etc.)
can now be controlled.
• Press [PRE] in the SECTION CONTROL section, and
then press [Sub parameter 2] to use a [Multi function
knob] to control the "HA GAIN" and "HA GC" on the
input channel where the R series device is connected.
• Press [e] (edit) on the input channel where the R series
device is connected, and then press [PRE] in the
SECTION CONTROL section to use a [Multi function
knob] to control the "HA GAIN", "HA GC", "HA HPF",
and "HA +48V" on the channel where [e] was pressed.
If an input bus with multiple channels (such as stereo or
surround channels) has been assigned, the parameters
for the bus channel appearing first in Nuendo's "VST
Connections" ("Left" for a stereo channel) are shown.
The values that have been set with Nuage Fader are
applied to all channels on that bus. (The settings for "Left"
(channel) are also applied to "Right" (channel), even
though that channel does not appear on the screen.)
If the values for all channels on a bus are not the same, an
asterisk (*) is added after the parameter. ("HA GAIN*", for
example)
Operation Function
"HA GAIN" Adjusts the gain.
"HA GC" Turns the gain compensation on and off.
"HA HPF" Turns the high pass filter on and off. You can
also adjust the filter frequency (20 – 600 Hz).
"HA +48V" Turns +48 V phantom power on and off. To
turn on phantom power, press and hold down
[Multi function button A].
R series settings
In the Nuendo menu, select "Devices"  "NUAGE HA
Remote Setup" to open the settings screen and configure
the Dante Accelerator you will use.
Added quick control setting
screen (Nuage Master)
The parameters for "Quick Controls" assigned to a
channel can now be edited on the [Multi Function
Display].
CHANNEL CONTROL –
QUICK CONTROL Page
1 2
1 (Nuendo)
Opens the Nuendo "Channel Settings" screen. Click again
to close the screen.
Parameters
2
Shows the parameters for "Quick Controls" assigned to
the selected channel. The values for each parameter can
be changed by dragging on the screen or using the
corresponding [Multi function knob].
Added functions in NUAGE V1.5 71