Control Change - Yamaha MOTIF6 Owner's Manual

■ Program Change
These events determine the selected voice for the note
data. Keep in mind that Program Change events can be
inserted at any point in a song track, letting you change
voices in the middle of a song.
Bank Select MSB
Bank Select LSB
• Bank Select MSB, LSB
Determines the voice bank.
❏ Settings
***~127
n Bank select MSB and LSB are actually part of the
Control Change set of messages (below).
However, since they apply specifically to voice
selection, they grouped and described here.
• Program number
Determines the specific voice (from the bank selected by
MSB and LSB above).
❏ Settings
001~128
n For a complete list of the available voice banks and
numbers, refer to the Voice List in the separate
Data List booklet.

■ Control Change

These events control the sound and certain response
characteristics of the voice, and are usually generated/
recorded by moving a controller (such as a modulation
wheel, knob, slider or foot controller).
Control number
• Control number
Determines the Control Change number. (See chart
below.)
❏ Settings
000~127
Control
Function
Number
001 Modulation Wheel
005 Portamento Time
007 Volume
010 Pan (Stereo position)
011 Expression
064 Sustain (Hold 1)
065 Portamento on/off
066 Sostenuto pedal on/off
067 Soft Pedal on/off
071 Harmonic Content (controls Filter Resonance)
074 Brightness (controls Filter Cutoff Frequency)
084 Portamento Source Note Number
120 All Sound Off
Program number
Voice name
Data
n For details on using Control Change numbers
(including those above), refer to the separate Data
List booklet.
■ Channel Aftertouch (CAT)
This event is generated when pressure is applied to a
key after the note is played.
• Data
This represents the amount of pressure applied to the key.
❏ Settings
000~127
■ Polyphonic Aftertouch (PAT)
This event is generated when pressure is applied to a
key after the note is played. Unlike Channel Aftertouch
above, this is recorded and applied independently for
each key pressed.
Note name
• Note name
Determines the key to which aftertouch is applied.
❏ Settings
C -2~G8
• Data
This represents the amount of pressure applied to the key.
❏ Settings
000~127
■ Registered Parameter Number (RPN)
This event changes parameter values for each tone
generator part.
This event is used to set part settings such as Pitch
Bend Sensitivity or Tuning.
For a complete list of the available RPN numbers and
their corresponding controls, refer to the MIDI Data
Format in the separate Data List booklet.
Song Edit mode
Data
Data
RPN MSB-LSB Data Entry
MSB-LSB
191
MOTIF Reference