Yamaha MOTIF6 Owner's Manual page 286

Installing Optional Hardware
Flip over the AIEB2 taking care not to bend
or damage the flat ribbon cable.
10
Let the ribbon cable fall into place between the
AIEB2 and the circuit board of the MOTIF.
Underside of the MOTIF
m-LAN CN5
AIEB2
Underside of the MOTIF
m-LAN CN5
AIEB2
11
Re-install the cover you removed in earlier steps,
in reverse order.
286
MOTIF Appendix
AIEB2
Slide the flat ribbon cable
in the space between the MOTIF
and the AIEB2.
Rear panel of the MOTIF
Rear panel of the MOTIF
Installing the mLAN8E
1
Using the same procedure as in steps 1 - 4 of
"Installing the AIEB2" above, remove the cover on
the underside of the MOTIF, then remove the
cover of the mLAN/I/O expansion bay.
2
Remove the mLAN8E from its package and
connect the included flat ribbon cable. Securely
fasten the flat ribbon cable to the rear panel of the
mLAN8E. Make sure that the ribbon is at the
bottom, as shown.
Top of mLAN8E
Make sure that flat ribbon cable is
at bottom of connector.
Front panel of mLAN8E
Make sure the flat ribbon cable sticks out from
the bottom and that the panel printing "mLAN8E"
can be seen.
3
Hold the mLAN8E upside down, and insert the
connector on the other end of the flat ribbon cable,
to the circuit board of the MOTIF.
m-LAN CN5
Underside of mLAN8E
Front panel of mLAN8E
(This example illustration shows the MOTIF6/MOTIF7.)
Rear panel of mLAN8E
Align the connectors as shown.
Underside of the MOTIF
Rear panel of the MOTIF