Yamaha MOTIF6 Owner's Manual page 283

4
Insert the board along the guide rails about two-
thirds of the way inside the MOTIF, with the
connector side face up and toward you.
ASSIGNABLE OUTPUT
R L
Securely insert the board into the appropriate slot,
taking care that the board isn't jammed between slots.
5
With the board still protruding slightly from the
expansion bay, bring the cable end around and
connect it to the board. Make sure to connect the
proper cable, matching the color of the cable to the
slot used. Also, take care not to pull on the cable
too forcefully as you connect it to the board.
Plug-in Connector
Notch
Connector from MOTIF Plug-in board
Plug-in SLOT
ASSIGNABLE OUTPUT
OUTPUT
R L R L MONO PHONES
n The Vocal Harmony Plug-in board (PLG100-VH) can
installed only to slot 1.
n The Multi part Plug-in board (PLG-100XG) can installed
only to slot 3.
Optional AIEB2 or mLAN8E
3
GREEN
2 YELLOW
Plug-in SLOT 1 ORANGE
OUTPUT A D INPUT
GAIN
R L MONO PHONES R L
Slot 3
Slot 2
Slot 1
Press the connectors together
until the two notches lock into
the sockets.
3
GREEN
2 YELLOW
1 ORANGE
A D INPUT
GAIN
R L
6
Insert the Plug-in board the rest of the way into
the expansion bay. Carefully put the the ribbon
cable back into the MOTIF, making sure that no
part of the cable sticks out of the instrument.
Plug- in SLOT
ASSIGNABLE OUTPUT
OUTPUT
R L
R L MONO PHONES
7
Replace the cover with the screw you removed in
step 2 above. The Plug-in board is held in place by
replacing the cover.
8
Check that the installed Plug-in board is
functioning properly. Turn on the power.
• A message appears indicating that the installed Plug-in
Board is being checked. The main display then appears
and the corresponding slot indicator at the right top of the
front panel lights. This indicates that the board has been
successfully installed.
• If an error message appears, the MOTIF freezes after a
while, indicating that the installation was not successful. If
this happens, turn off the power and carefully go through
the installation procedure again.
In this example, a Plug-in board has been installed to slot 1.
MUSIC PRODUCTION SYNTHESIZER
Integrated Sampling Sequencer
Real-time External Control Sur face
Modular Synthesis Plug-in System
DRUM KITS PRE 1 PRE 2 PRE 3 GM USER
FAVORITES A. PIANO KEYBOARD ORGAN GUITAR / BASS
PLUCKED
COMMON
A B C D E
SYN LEAD SYN PAD/ SYN COMP CHROMATIC DRUM /
PERCUSSION PERCUSSION
CHOIR
Installation
Installing Optional Hardware
3
GREEN
2
YELLOW
1 ORANGE
A D INPUT
GAIN
R
L
Slot indicator lamps
SLOT 1 SLOT 2 SLOT 3
CATEGORY
PLG 1 PLG 2 PLG 3 SEARCH BANK
STRINGS BRASS REED/PIPE
GROUP
F G H SECTION
SE MUSICAL FX COMBI
283
MOTIF Appendix