Yamaha MOTIF6 Owner's Manual page 285

5
Remove the AIEB2 power cables from the hook-
shaped cable clip in the MOTIF.
MOTIF6 / MOTIF7
Top (keyboard side) of the MOTIF
Rear panel of the MOTIF
MOTIF8
Top (keyboard side) of the MOTIF
Rear panel of the MOTIF
6
Remove the AIEB2 from its package. The AIEB2
has one flat ribbon cable and two power cables.
Since these two power cables are used for the main
body and are not needed when installing to the
MOTIF, you can remove them from the AIEB2.
AIEB2
Underside of the MOTIF
Unlatch the cable clip by
pulling out the tab as shown.
Replace the clip after pulling
out the power cable.
Underside of the MOTIF
Remove the two
power cables.
7
Connect the flat ribbon cable coming from AIEB2
to the circuit board of the MOTIF. Be careful to
connect in the proper direction as shown.
Make sure that the direction is correct and do not try to
force the connection.
m-LAN CN5
8
Connect the power cable coming from MOTIF to
the AIEB2. Connect the 3-pin cable to the CN3
connector of the AIEB2, and the 4-pin cable to the
CN1 connector.
m-LAN CN5
Connect the 4-pin cable
to the CN1 connector
* Make sure to properly match the cables and connectors.
Avoid applying excessive force when connecting.
9
Fasten the AIEB2 to the MOTIF. Flip the unit
over, so that the bottom of the plate can be seen,
and that each connector section of the AIEB2 can
be seen from the back side of MOTIF. Supporting
the unit with one hand, attach it to the rear of the
MOTIF with the three screws you removed in step
4. If you start replacing the screws from the center
screw, it will be easy to replace the remaining
screws.
Installing Optional Hardware
Flat ribbon cable
of the AIEB2
Align the
connectors
as shown.
Connector on
the circuit board
of the MOTIF
Rear panel of the MOTIF
AIEB2
Connect the 3-pin cable
to the CN3 connector
285
MOTIF Appendix