4.1 O ve rvie w
This chapter provides tutorials for setting up your LTE3301.
•
Set Up a Wireless Network Using WPS
•
Connect to LTE3301 Wireless Network without WPS
•
Using Multiple SSIDs on the LTE3301
4.2 Se t Up a Wire le ss Ne two rk Using WPS
This section gives you an example of how to set up wireless network using WPS. This example uses the
LTE3301 as the AP and NWD210N as the wireless client which connects to a notebook.
Note: The wireless client must be a WPS-aware device (for example, a WPS USB adapter or
PCI card).
There are two WPS methods for creating a secure connection via the web configurator or utility. This
tutorial shows you how to do both.
•
Push Butto n C o nfig ura tio n (PBC )
Section 4.2.1 on page
•
PIN C o nfig ura tio n
Identification Number) in the LTE3301's interface. See
method, since one device can authenticate the other.
4.2.1 Push Butto n C o nfig ura tio n (PBC )
Make sure that your LTE3301 is turned on. Make sure the
1
pushed in, and that the device is placed within range of your notebook.
Make sure that you have installed the wireless client (this example uses the NWD210N) driver and utility in
2
your notebook.
In the wireless client utility, find the WPS settings. Enable WPS and press the WPS button (
3
button)
Log into LTE3301's Web Configurator and press the
4
L AN 2.4G > WPS Sta tio n
- create a secure wireless network simply by pressing a button. See
30. This is the easier method.
- create a secure wireless network simply by entering a wireless client's PIN (Personal
screen.
LTE3301 Series User's Guide
30
C
HA PTER
T uto ria ls
Section 4.2.2 on page
button (at the back panel of the LTE3301) is
WIFI
in the
Push Butto n
C o nfig ura tio n > Ne two rk > Wire le ss
4
31. This is the more secure
or
Sta rt
WPS