Network Scan - ZyXEL Communications LTE3301 Series User Manual

6.5 Ne two rk Sc a n
Use this screen to set how you want the LTE3301 to connect to an available mobile network. Click
>
Ne two rk WAN > Ne two rk Sc a n
Network > WAN > Network Scan
Fig ure 31
The following table describes the labels in this screen.
Table 15 Network > WAN > Network Scan
L ABEL
Physical Interface
Network Type
Scan Approach
Network Provider List
Provider Name
Mobile System
Network Status
Action
Apply
Cancel
Refresh
Chapter 6 WAN
from the
C o nfig ura tio n
DESC RIPT IO N
This shows the type of the interface used by the WAN connection.
Select the type of the network (
LTE3301 to connect when there is a SIM card inserted.
Select to have the LTE3301 connect to an available network using the default
Auto
settings on the SIM card. If the currently registered mobile network is not available or the
mobile network's signal strength is too low, the LTE3301 switches to another available
mobile network.
Select to search for and select the mobile network(s) to which you want the
Ma nua lly
LTE3301 to connect.
This table is available only when you set
Click to search for available mobile networks based on the network type you
Sc a n
selected.
Click to save your changes in the
Apply
This shows the name of the service provider.
This shows the mobile telecommunications standard supported by the mobile network.
This shows whether the mobile network is available.
Click to have the LTE3301 establish a connection to the selected mobile network.
Se le c t
Click to save your changes back to the LTE3301.
Apply
Click to reload the previous configuration for this screen.
C a nc e l
Click to update this screen.
Re fre sh
LTE3301 Series User's Guide
56
menu.
, , or ) to which you want the
4G o nly 3G o nly 3G / 4G
to
Sc a n Appro a c h Ma nua lly
field.
Ac tio n
.