Add/Edit Static Route - ZyXEL Communications VMG8324-B10A series User Manual

8.2.1 Add/Edit Static Route

Use this screen to add or edit a static route. Click Add new static route in the Routing screen or
the Edit icon next to the static route you want to edit. The screen shown next appears.
Figure 68 Routing: Add/Edit
The following table describes the labels in this screen.
Table 41 Routing: Add/Edit
LABEL
Active
Route Name
IP Type
Destination IP
Address
IP Subnet Mask
Use Gateway IP
Address
Gateway IP
Address
Use Interface
Apply
Cancel
VMG8324-B10A / VMG8324-B30A Series User's Guide
DESCRIPTION
This field allows you to activate/deactivate this static route.
Select this to enable the static route. Clear this to disable this static route without having to
delete the entry.
Enter a descriptive name for the static route.
Select whether your IP type is IPv4 or IPv6.
Enter the IPv4 or IPv6 network address of the final destination.
If you are using IPv4 and need to specify a route to a single host, use a subnet mask of
255.255.255.255 in the subnet mask field to force the network number to be identical to
the host ID. Enter the IP subnet mask here.
The gateway is a router or switch on the same network segment as the device's LAN or WAN
port. The gateway helps forward packets to their destinations.
If you want to use the gateway IP address, select Enable.
Enter the IP address of the gateway.
Select the WAN interface you want to use for this static route.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Chapter 8 Routing
133