Dynamic Routing Screen - ZyXEL Communications LTE3301 Series User Manual

Table 43 Network > Routing > Static Route: Add/Edit
L ABEL
IP Subnet Mask
Gateway IP
Address
Back
Apply
Cancel
12.3 Dyna m ic Ro uting Sc re e n
Use this screen to enable and configure RIP on the LTE3301. Click
to open the
Network > Routing > Dynamic Routing
Fig ure 66
The following table describes the labels in this screen.
Table 44 Network > Routing > Dynamic Routing
L ABEL
Dynamic Routing
Apply
Cancel
Chapter 12 Routing
DESC RIPT IO N
Enter the IP subnet mask here.
Enter the IP address of the next-hop gateway. The gateway is a router or switch on the same
segment as your LTE3301's interface(s). The gateway helps forward packets to their
destinations.
Click to return to the previous screen without saving.
Ba c k
Click to save your changes back to the LTE3301.
Apply
Click to set every field in this screen to its last-saved value.
C a nc e l
screen.
Dyna m ic Ro uting
DESC RIPT IO N
RIP (Routing Information Protocol) allows a router to exchange routing information with other
routers. The RIP version controls the format and the broadcasting method of the RIP packets
that the LTE3301 sends (it recognizes both formats when receiving). RIP version 1 is universally
supported but RIP version 2 carries more information. RIP version 1 is probably adequate for
most networks, unless you have an unusual network topology.
Select the RIP version from
Click to save your changes back to the LTE3301.
Apply
Click to begin configuring this screen afresh.
C a nc e l
LTE3301 Series User's Guide
Ne two rk > Ro uting > Dyna m ic Ro uting
and . Otherwise, select
RIPv1 RIPv2
100
to turn if off.
Disa b le