Ricoh Sirius-SC1fn Service Manual page 14

MAINFRAME AND OPTION INSTALLATION PROCEDURES
[A]
13. Insert the stepped screws (! x 2) to the holes [A] on the base board. Then
secure them to the screw holes [B] on the rack.
Important
Secure the stepped screws to the screw hole [B] on the Rack till the screw
does not turn. Make sure that the Stepped Screws are fully through the holes
[A] on the base board.
NOTE: Keep the base board to the position where you have secured the
stepped screw to the screw hole [B] on the rack.
14. Set the scanner on the table board [C].
NOTE: Set the scanner so that the
legs of the scanner fit the
dents [D] on the table board.
15. Secure the scanner with the stepped
screws (! x 2) into the screw holes [E].
[E]
[D]
1-8
3 December 2004
[A]
[B]
G422I217.WMF
G422I218.WMF
[D]
[C]