Table of Contents
Advertisement
MAINFRAME AND OPTION INSTALLATION PROCEDURES
Installation procedure
Assembling the Rack
1. Insert the upper stand [B] into the
lower stand [A] as shown.
Important
Insert the upper stand [B] into the
lower stand [A] till the two screw holes
are correctly lined.
2. Insert the adjuster screws (! x 2)
[C] to the 2 screw holes [D] on the
bottom of the stand.
Important
Secure the adjuster screws till the
stand is 65-67mm from the floor.
NOTE: To set the stand to 65-
67mm above the floor,
put in the adjuster screw
till it is tightly secured.
Then turn it for 1 or 2
turns.
3. Insert the M5x10W screws (! x 2) [E]
to the 2 screw holes [F] at the
connection of upper and lower stand.
NOTE: Use the screw driver (that
comes with the Rack) when
you assemble the rack.
4. Do steps 1 to 3 again to put the adjuster screws (! x 2) to the remaining holes
on the bottom of the stand.
[A]
65-67mm
1-4
3 December 2004
[B]
G422I201.WMF
[D]
[C]
G422I212.WMF
[F]
G422I213.WMF
[E]
Advertisement
Table of Contents
