Detecto ICON Series Owner's Manual page 55

Enable and Configure Wi-Fi Networking, Cont.
10. Press the >>> key to advance to the Settings Page 8.
SETTINGS
DHCP: On
IP: 192.168.0.133
NM: 255.255.255.0
GW: 192.168.0.1
<<<
11. Touch the DHCP: key to open an entry screen to allow you to select the DHCP setting.
This setting selects whether the Wi-Fi wireless transmitter will use a dynamic IP address
assigned by a DHCP server or a static IP address. Consult your network administrator
for the proper selection.
Using the numeric keys, enter a new setting, 0 = Static IP (Off) or 1 = DHCP (On) and
then press the Save key.
NOTE: If the setting for DHCP: = Off, the settings for NM: (Netmask) and GW:
(Gateway Address) will be shown on the touchscreen.
12. Touch the NM: key to open an entry screen to enter the Wi-Fi network Netmask for the
network the scale will be connected to, and then press the Save key.
The Netmask of the scale should match the Netmask of the other computers on your
network. The format for the Netmask is: ### . ### . ### . # (e.g., 255.255.255.0).
13. Touch the GW: key to open an entry screen to enter the Wi-Fi network Gateway Address
for the network the scale will be connected to, and then press the Save key.
The format for the Gateway address is: # . # . # . # (e.g., 192.168.0.1).
14. Press the Exit key to exit Setup and return to the Weight screen.
15. Proceed to the Configure Wi-Fi Network Module section.
3300-0192-0M Rev H icon Clinical Scale Owner's
PAGE 8
Exit
The settings for NM:
and GW: will not be
shown if DHCP = On.
49