Summary Of Device Status Commands - Avaya G450 Manual

Summary of device status commands

For more information about these commands, see Avaya G450 CLI Reference, 03-300437.
Table 18: Device status commands
Command
set utilization
cpu
show faults
show image
version
show mg
list_config
show mgc
show mm
show module
show restart-log
show system
show temp
show timeout
show utilization
show voltages
test led
Description
Enable CPU utilization measurements
Display information about currently active faults
Display the software version of the image on both memory banks of
the device
Display the current hardware and firmware configurations for the
installed media gateway equipment
Display information about the Media Gateway Controller with which
the G450 is registered
Display information about media modules that are installed on the
G450
Display brief information about the media modules installed in the
G450
Display information about the last time the G450 was reset
Display information about the G450
Display the device temperature
Display the amount of time in minutes the terminal remains idle
before timing out
Display information about CPU and memory usage on the G450
Display power supply voltages
Test the system ALM, MDM and CPU LEDs on the front panel of the
G450
Viewing the status of the device
Issue 1 January 2008 97