Xerox Document WorkCentre 450C User Manual page 73

To switch from pulse to touch-tone dialing, you need to
change the PAUSE key setting from pause only (the
default) to dial options. This procedure describes how to
change the PAUSE key setting.
1. At the WorkCentre 450c, press the MENU key.
2. Press 5 [Setup] and ENTER.
3. Press 7 [Control panel] and ENTER.
4. Press 4 [Pause key] and ENTER.
5. Press RIGHT ARROW to display [dial options] and
ENTER.
The WorkCentre sounds a confirmation beep.
6. Press STOP to exit the menus.
7. Load up to 20 pages face down in the document tray.
8. Begin dialing the fax number.
9. When you need to switch to touch-tone dialing, press
the PAUSE key to display the dial options.
10. Press the RIGHT ARROW key twice to display [tone
dialing] and then press ENTER. The letter "T"
displays on the LCD, which indicates that the next
number you enter will use touch-tone dialing.
11. Enter the next fax number.
73