Software/Configuration Troubleshooting - Garmin G1000 Manual

2.8 Software/Configuration Troubleshooting

Problem
GDU 1040 MFD or PFD display does not power up
Software file load fails:
Configuration file load fails:
Software File Mismatch Alert appears in lower right
corner of PFD when started in normal mode:
Page 2-22
Revision 1
• Ensure that the criteria listed in 2.8.1 are fulfilled for
• Ensure power is present at display backshell
• Replace display.
• Ensure that criteria listed in 2.8.1 are fulfilled for the
• Ensure that any data paths to the LRU are open at
• Retry software file load or try using a different card.
• Ensure that LRU part number is compatible with
• Replace LRU.
• Ensure that criteria listed in 2.8.1 are fulfilled for the
• Ensure that LRU is reporting data on System Status
• Retry configuration file load or try using a different
• Ensure that LRU part number is compatible with
• Replace LRU.
• Ensure that proper software file part number and
• Check and ensure that correct Loader Card was
• Reload software to LRU.
G1000 V8.XX S/W Load and Post Install Checkout – Columbia 350/400
Solutions
the applicable situation.
connector.
applicable situation.
System Status page. Check data path wiring as
needed.
Ensure that the MFD is not touched during the
loading process.
software version and Loader Card. Refer to the
Required Equipment List and to Section 2.5.3 of this
document.
applicable situation.
page. Check data path wiring as needed.
card. Ensure that the MFD is not touched during the
loading process.
Loader Card. Refer to the Required Equipment List
and to Section 2.4.8 of this document.
version were loaded to LRU. Refer to the Required
Equipment List, Sections2.6, and 2.8.1.
used during load process. Refer to the Required
Equipment List.
190-00577-04