Garmin G1000 Manual page 45

14. Verify that the A/P DISCONNECT boxes in the GIA STATUS, MONITOR BOARD STATUS
and CONTROL BOARD STATUS areas are green.
15. Press the A/P DISC switch on the pilot's control stick and verify that the green boxes in the GIA
STATUS and CONTROL BOARD STATUS areas are black while the A/P DISC switch is
pressed.
The A/P DISCONNECT box in the MONITOR BOARD STATUS area will
remain green for up to 20 seconds after the A/P DISC switch is pressed. It is not
necessary to wait for this box to change from green to black, since this takes its
input from the same pin as the CONTROL BOARD STATUS.
16. Press the A/P DISC switch on the copilot's control stick and verify that the green boxes in the
GIA STATUS and CONTROL BOARD STATUS areas are black while the A/P DISC switch is
pressed.
If the servo PFT status is listed as FAILED and the HIGH RES LOAD CELL
CAL and HIGH RNG LOAD CELL CAL boxes are green, reload the servo gains
before replacing the servo.
17. In the MONITOR BOARD STATUS area, verify that the PFT says PASSED and the boxes
beside the HIGH RES LOAD CELL CAL and HIGH RNG LOAD CELL CAL boxes are green.
If the either or both of the boxes beside the HIGH RES LOAD CELL CAL and HIGH RNG
LOAD CELL CAL are red or the PFT status is FAILED, the servo must be replaced.
18. Activate the cursor and use the small FMS knob to highlight ROLL SERVO in the SELECT
SERVO AXIS field and then press the ENT key. The ROLL SERVO GFC STATUS page will
now be shown.
G1000 V8.XX S/W Load and Post Install Checkout – Columbia 350/400
190-00577-04
NOTE
NOTE
Page 3-3
Revision 1