Table of Contents
Advertisement
1.8 Wa ll Mo unting
You may need screw anchors if mounting on a concrete or brick wall.
Table 3 Wall Mounting Information
Distance between holes
M4 Screws
Screw anchors (optional)
Screw Specifications
Fig ure 3
Select a position free of obstructions on a wall strong enough to hold the weight of the device.
1
Mark two holes on the wall at the appropriate distance apart for the screws.
2
Be c a re ful to a vo id da m a g ing pipe s o r c a b le s lo c a te d inside the wa ll
whe n drilling ho le s fo r the sc re ws.
If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the full
3
depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way in - leave
a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the screws all
the way in - leave a gap of about 0.5 cm.
Make sure the screws are fastened well enough to hold the weight of the NBG6604 with the connection
4
cables.
Align the holes on the back of the NBG6604 with the screws on the wall. Hang the NBG6604 on the
5
screws.
Chapter 1 Introduction
83 mm
Two
Two
NBG6604 User's Guide
12
Advertisement
Table of Contents
