Table of Contents
Advertisement
Table 15 Network > WAN > Internet Connection: PPPoE Encapsulation (continued)
L ABEL
DESC RIPT IO N
IDLE Timeout
This value specifies the time in minutes that elapses before the router automatically
(second)
disconnects from the PPPoE server.
PPPoE Service
Enter the PPPoE service name specified in the ISP account.
Name
WAN IP Address Assignment
Get automatically
Select this option if your ISP did not assign you a fixed IP address. This is the default selection.
from ISP
Use Fixed IP Address Select this option and enter your WAN IP address if the ISP assigned a fixed IP address.
DNS Server
First DNS Server
Select
NBG6604's WAN IP address). The field to the right displays the (read-only) DNS server IP
Second DNS Server
address that the ISP assigns.
Third DNS Server
Select
address in the field to the right.
Select
you must know the IP address of a computer in order to access it.
WAN MAC Address
The MAC address section allows users to configure the WAN port's MAC address by using the NBG6604's MAC
address, copying the MAC address from a computer on your LAN or manually entering a MAC address.
Factory default
Select
Clone the
Select
computer's MAC
computer on the LAN whose MAC you are cloning.
address - IP Address
Set WAN MAC
Select this option and enter the MAC address you want to use.
Address
Automatically
Select this to have the NBG6604 detect the relay server's IP address automatically through
configured by
DHCP.
DHCPC
Manually
Select this if you have the IPv4 address of the relay server.
Configured
Border Relay IPv4
Specify the relay server's IPv4 address.
Address
IPv4 mask length
Enter the subnet mask number (1~32) for the IPv4 network.
Remote IPv4
Enter the IPv4 address of the remote gateway to which this interface tunnels traffic.
Address
Multicast Setup
Multicast Setup
Select
LAN.
Select
all connected network devices.
Auto-Subnet Configuration
Chapter 9 WAN
if your ISP dynamically assigns DNS server information (and the
O b ta ine d Fro m ISP
if you have the IP address of a DNS server. Enter the DNS server's IP
Use r- De fine d
if you do not want to configure DNS servers. If you do not configure a DNS server,
No ne
to use the factory assigned default MAC Address.
Fa c to ry de fa ult
C lo ne the c o m pute r's MAC a ddre ss - IP Addre ss
to enable multicasting. This applies to traffic routed from the WAN to the
IG MPv1/ v2
to disable this feature. This may cause incoming traffic to be dropped or sent to
No ne
NBG6604 User's Guide
57
and enter the IP address of the
Advertisement
Table of Contents
