Table of Contents
Advertisement
The table below describes the labels in the screen.
Table 12 LAN > LAN IP
L ABEL
IP Address
Obtain an IP Address
Automatically
Static IP Address
IP Address
Subnet Mask
Default Gateway
DNS Server
First DNS Server
Second DNS Server
Third DNS Server
Apply
Cancel
Chapter 6 Access Point Mode
DESC RIPT IO N
When you enable this, the NBG6604 gets its IP address from the network's DHCP server
(for example, your ISP). Users connected to the NBG6604 can now access the network
(i.e., the Internet if the IP address is given by the ISP).
The Web Configurator may no longer be accessible unless you know the IP address
assigned by the DHCP server to the NBG6604. You need to reset the NBG6604 to be
able to access the Web Configurator again (see
how to reset the NBG6604).
Also when you select this, you cannot enter an IP address for your NBG6604 in the field
below.
Click this if you want to specify the IP address of your NBG6604. Or if your ISP or network
administrator gave you a static IP address to access the network or the Internet.
Type the IP address in dotted decimal notation. The default setting is 192.168.1.2. If you
change the IP address you will have to log in again with the new IP address.
The subnet mask specifies the network number portion of an IP address. Your NBG6604
will automatically calculate the subnet mask based on the IP address that you assign.
Unless you are implementing subnetting, use the subnet mask computed by the
NBG6604.
Enter a
's IP address (if your ISP or network administrator gave you one)
De fa ult G a te wa y
in this field.
Select
if your ISP dynamically assigns DNS server information (and the
O b ta ine d Fro m ISP
NBG6604's WAN IP address). The field to the right displays the (read-only) DNS server IP
address that the ISP assigns.
Select
if you have the IP address of a DNS server. Enter the DNS server's IP
Use r- De fine d
address in the field to the right. If you chose
0.0.0.0,
changes to
Use r- De fine d
to
, and enter the same IP address, the second
Use r- De fine d
after you click
.
No ne
Apply
Select
if you do not want to configure DNS servers. If you do not configure a DNS
No ne
server, you must know the IP address of a computer in order to access it.
Click
to save your changes to the NBG6604.
Apply
Click
to reload the previous configuration for this screen.
C a nc e l
NBG6604 User's Guide
37
Section 14.7 on page 95
, but leave the IP address set to
Use r- De fine d
after you click
. If you set a second choice
No ne
Apply
Use r- De fine d
for details on
changes to
Advertisement
Table of Contents
