Table of Contents
Advertisement
The following table describes the rear panel LEDs.
Table 2 Rear Panel LEDs
LED
LAN 1-4
WAN
1.8 Wall Mounting
You may need screw anchors if mounting on a concrete or brick wall.
Table 3 Wall Mounting Information
Distance between holes
M4 Screws
Screw anchors (optional)
Select a position free of obstructions on a wall strong enough to hold the weight of the device.
1
Mark two holes on the wall at the appropriate distance apart for the screws.
2
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the
3
full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way
in - leave a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the
screws all the way in - leave a gap of about 0.5 cm.
Make sure the screws are fastened well enough to hold the weight of the ARMOR Z1 with the
4
connection cables.
Align the holes on the back of the ARMOR Z1 with the screws on the wall. Hang the ARMOR Z1 on
5
the screws.
Chapter 1 Introduction
COLOR
STATUS
DESCRIPTION
Green
On
The ARMOR Z1's LAN connection is ready.
Blinking
The ARMOR Z1 is sending/receiving data through the LAN.
Off
The LAN connection is not ready, or has failed.
Green
On
The ARMOR Z1's WAN connection is ready.
Blinking
The ARMOR Z1 is sending/receiving data through the WAN.
Off
The WAN connection is not ready, or has failed.
ARMOR Z1 User's Guide
12.45 cm
Two
Two
14
Advertisement
Table of Contents
