Fluke 5730A Calibration Manual page 24

5730A
Calibration Manual
5725A Amplifier:
Range Frequency
(Hz)
40 - 1 k
1 k - 20 k
1100 V
20 k - 50 k
50 k - 100 k
Notes:
1. Stability specifications are included in Absolute specification values for the primary specifications.
2. The 5725A will drive up to 1000 pF of load capacitance. Absolute specifications include loads to 300 pF and 150 pF as shown
under "Load Limits." For capacitances up to the maximum of 1000 pF, add "Load Regulation."
Voltage Range
[2]
2.2 V
22 V
220 V
1100 V
5725A Amplifier:
1100 V
Notes:
1. The 5725A will drive up to 1000 pF of load capacitance. Absolute specifications include loads to 300 pF and 150 pF as shown
under "Load Limits." For capacitances up to the maximum of 1000 pF, add "Load Regulation."
2. 2.2 V Range, 100 kHz-1.2 MHz only: Absolute specifications cover loads to 10 mA or 1000 pF. For higher loads, load regulation
is added.
Applies from 0 °C to 40 °C.
3.
Output Display Formats ....................................... Voltage or dBm, dBm reference 600 Ω.
Minimum Output ................................................... 10 % on each range
External Sense ...................................................... Applicable for 2.2 V, 22 V, 220 V, and 1100 V ranges; 5730A
Notes:
Plus 1 second for amplitude or frequency range change
Plus 2 seconds for 5730A 1100 V range
Plus 4 seconds for 5725A 1100 V range
Overshoot .............................................................. <10 %
Common Mode Rejection
14
Temperature Coefficient
Stability
[1]
±1 °C
10 - 40 °C
24 Hours
±(ppm output + mV) ±(ppm output) / °C
10 + .5 5
15 + 2 5
40 + 2 10
130 + 2 30
Maximum Current Limits
50 mA, 0 °C-40 °C
20 mA, 40 °C-50 °C
6 mA
40 Hz-5 kHz
5 kHz-30 kHz
30 kHz-100 kHz
<100 kHz, 5725A <30 kHz. Specifications are the same as internal
sense.
Settling Time to Published Specifications
Frequency (Hz)
10-120
>120
....................................... 140 dB, dc to 400 Hz
Adder
Load Regulation
0 - 10 °C and
40 - 50 °C
±(ppm output + mV)
5
5
10 275 + 11
30 500 + 30
50 mA
70 mA
[3]
70 mA
Settling Time (seconds)
Distortion
Bandwidth
[2]
10 Hz -10 MHz
±(% output)
150 pF 1000 pF
10 + 1 0.10
90 + 6 0.10
0.30
0.40
Load Limits
>50 Ω,
1000 pF
600 pF
[1]
1000 pF
300 pF
150 pF
7
5
0.10
0.15
0.30
0.40