Safety Information - Fluke 5730A Calibration Manual

Safety Information

A Warning identifies conditions and procedures that are dangerous to the user.
A Caution identifies conditions and procedures that can cause damage to the
Product or the equipment under test.
To prevent possible electrical shock, fire, or personal injury:
•
Read all safety information before you use the Product.
•
Carefully read all instructions.
•
Do not use the Product around explosive gas, vapor, or in
damp or wet environments.
•
Use this Product indoors only.
•
Do not put the Product where access to the mains power
cord is blocked.
•
Use only the mains power cord and connector approved for
the voltage and plug configuration in your country and rated
for the Product.
•
Replace the mains power cord if the insulation is damaged
or if the insulation shows signs of wear.
•
Make sure the ground conductor in the mains power cord is
connected to a protective earth ground. Disruption of the
protective earth could put voltage on the chassis that could
cause death.
•
Do not use an extension cord or adapter plug.
•
Do not operate the Product with covers removed or the case
open. Hazardous voltage exposure is possible.
•
Do not use the Product if it operates incorrectly.
•
Do not connect to live output terminals. The Product can
supply voltages that can cause death. Standby mode is not
sufficient to prevent electrical shock.
•
Do not apply more than the rated voltage, between the
terminals or between each terminal and earth ground.
•
Use only cables with correct voltage ratings.
•
Do not touch exposed metal on banana plugs, they can have
voltages that could cause death.
•
Do not touch voltages >30 V ac rms, 42 V ac peak, or 60 V dc.
•
Use the Product only as specified, or the protection
supplied by the Product can be compromised.
•
Use only specified replacement fuses.
•
Have an approved technician repair the Product.
Warnings
Multifunction Calibrator
Safety Information
3