Seat Assembly - Weider Pro 4250 User Manual

55. Wrap the Ab Cable (107) over a 90mm Pulley
(63). Attach the Pulley and the two Quarter Finger
Guards (105) to the Right Upright (2) with an M10
x 106mm Bolt (72), an M10 Washer (99), and an
M10 Nylon Locknut (90). Make sure that the rod
is inserted through both Finger Guards and is
over the Cable.
56. Tighten the Weight Cable (110) into the Weight
Tube (not shown) until all the slack is taken out of
the cables. Tighten the M12 Nut (49) on the
Weight Cable against the M12 Washer (33).

Seat Assembly

57. Attach the Press Backrest (113) to the Backrest
Frame (53) with two M6 x 16mm Screws (88), an
M6 x 35mm Screw (78), and an M6 Washer (97).
Slide the Backrest Frame (53) into the Left
Upright (26). Engage the Knob (43) into the
Upright and Backrest Frame, and turn it clockwise
until it is tight.
58. Attach a Seat (8) to the Left Seat Frame (27) with
four M6 x 16mm Screws (88).
Repeat this step with the other Seat (8) and
the Right Seat Frame (not shown).
55
90
99
107
2
56
33
57
26
88
43
78
58
20
Rod
105
63
105
72
110
49
53
113
97
8
27
88
88