Fuji Xerox DocuCentre S2011 Basic Operation Manual page 48

Problem Solving
Error Code
010-311
[Cause]
010-312
[Remedy] Switch off the machine power, make sure that the display is blank, and then
010-320
010-327
010-379
010-392
010-602 [Cause]
[Remedy] The machine will automatically recover when the machine cools down. Wait for a
016-372
[Cause]
[Remedy] Switch off the machine power, make sure that the display is blank, and then
016-500
[Cause]
016-501
[Remedy] Switch off the machine power, make sure that the display is blank, and then
016-502
016-504
016-570 [Cause]
[Remedy] Press the control panel's <Stop> button, and cancel the job.
016-571
[Cause]
[Remedy] The machine will automatically recover. Wait a moment, and try again.
016-742
[Cause]
016-744
[Remedy] Switch off the machine power, make sure that the display is blank, and then
016-749
[Cause]
[Remedy] Press the control panel's <Stop> button, and cancel the job.
016-759 [Cause]
[Remedy] Press the control panel's <Stop> button, and cancel the job.
016-764 [Cause]
[Remedy] Press the control panel's <Stop> button and cancel the job.
016-776 [Cause]
[Remedy] Press the control panel's <Stop> button, and cancel the job.
016-799 [Cause]
[Remedy] Press the control panel's <Stop> button, and cancel the job.
016-981
[Cause]
[Remedy] Press the control panel's <Start> button to redo the operation, or press the <Stop>
016-982
[Cause]
[Remedy] Press the control panel's <Stop> button, and cancel the job.
48
Cause and Remedy
An error occurred.
switch on the machine power. If the same message is displayed again, contact
our Customer Support Center.
Temperature sensor of the machine detected abnormality.
while, and try again.
An error occurred.
switch on the machine power. If the same message is displayed again, contact
our Customer Support Center.
An error occurred.
switch on the machine power.
A communication error occurred while printing.
A communication error occurred during print processing.
An error occurred.
switch on the machine power.
An error occurred.
A setting has been entered for the maximum number of permitted copies, and
has been reached. Alternatively, a user who has reached their maximum number
of copies logged in.
An error occurred on the network.
A job is canceled.
An invalid print parameter is included in the print data of the application, or the
print data and the Print Setup settings may not match.
The EPC memory is full.
button to cancel the operation.
The memory is full while scanning the first page with Scan to PC service.