Fuji Xerox DocuCentre S2011 Basic Operation Manual page 46

Problem Solving
Error Code
The drum cartridge is defective.
The warranty period of the image quality on
the drum cartridge is expired.
The warranty period of performance on the
drum cartridge is expired.
The drum cartridge is defective.
Reached the maximum copy limit while the
limit is set. Also, the user who reached the
copy job limit has logged in.
The job is canceled due to out of memory in
reading.
The job is canceled.
Error code (XXX-XXX)
Error Code
003-500
[Cause]
[Remedy] Press the control panel's <Stop> button, and change the setting.
003-795 [Cause]
[Remedy] Press the control panel's <Stop> button, and change the setting.
003-942 [Cause]
[Remedy] Press the control panel's <Stop> button, and check the document.
003-956 [Cause]
[Remedy] Press the control panel's <Stop> button, and check the document.
003-963 [Cause]
[Remedy] Press the control panel's <Stop> button, and change the setting.
003-972 [Cause]
[Remedy] Press the control panel's <Start> button to redo the operation or press the <Stop>
003-973 [Cause]
[Remedy] Take one of the following measures.
004-345 [Cause]
[Remedy] Switch off the machine power, make sure that the display is blank, and then
46
Cause
Cause and Remedy
When using the Pages per Side function, the printout doesn't fit in the paper with
the specified reduction/enlargement factor.
When enlarging/reducing a scanned document to the paper size specified, the
reduction/enlargement ratio exceeds the allowed range.
A document with a non-standard size is set in the document feeder.
A document with a non-standard size is set on the document glass.
When [Auto] is set for [Paper Supply] for a copy job, the size of the scan document
is larger than the paper size that can be copied.
Exceeded the maximum pages that can be scanned during a copy/scan job.
button to cancel the operation.
The image size is too large when enlarging/reducing a scanned document that
does not match the orientation of paper.

Reduce the magnification with [Reduce/Enlarge].

Change the orientation of paper or document.
An error occurred.
switch on the machine power. If the same message is displayed again, contact
our Customer Support Center.
Remedy
Replace the drum cartridge.
It may affect the image quality. Replacing the
drum cartridge is recommended.
It may damage the machine. Replace the
drum cartridge.
Replace the drum cartridge immediately.
Otherwise, the machine will be damaged.
Press the <Stop> button, and contact your
system administrator.
Change the setting, and then try again.
Change the setting, and then try again.