Fuji Xerox DocuCentre S2011 Basic Operation Manual page 49

Error Code
024-365
[Cause]
[Remedy] Switch off the machine power, make sure that the display is blank, and then
024-910
[Cause]
[Remedy] Press the control panel's <Stop> button to cancel the job or change the paper to
024-911 [Cause]
[Remedy] Press the control panel's <Stop> button to cancel the job or change the paper to
024-915 [Cause]
[Remedy] Press the control panel's <Stop> button to cancel the job or change the paper to
024-950 [Cause]
[Remedy] Load more paper, or press the control panel's <Stop> button to cancel the job.
024-946
[Cause]
[Remedy] Confirm that the paper guide is adjusted to the paper size supported in Tray 1.
024-947
[Cause]
[Remedy] Confirm that the paper guide is adjusted to the paper size supported in Tray 2.
024-950
[Cause]
[Remedy] Load more paper, or press the control panel's <Stop> button to cancel the job.
024-951
[Cause]
[Remedy] Load more paper, or press the control panel's <Stop> button to cancel the job.
024-958 [Cause]
[Remedy] Press the control panel's <Stop> button, or check the position of the paper guides.
024-959 [Cause]
[Remedy] Press the control panel's <Stop> button and insert Tray 1, or check the position of
024-960 [Cause]
[Remedy] Press the control panel's <Stop> button and insert Tray 2, or check the position of
024-965 [Cause]
[Remedy] Load the specified paper, or press the control panel's <Stop> button to cancel the
024-966
[Cause]
[Remedy] Press the control panel's <Stop> button, and try again.
Cause and Remedy
An error occurred.
switch on the machine power. If the same message is displayed again, contact
our Customer Support Center.
The paper size set for Tray 1 and the paper size specified for the job are not the
same.
the specified paper size.
The paper size set for Tray 2 and the paper size specified for the job are not the
same.
the specified paper size.
The paper size set for the Bypass tray and the paper size specified for the job are
not the same.
the specified paper size.
There is no paper in Tray 1 and another tray cannot be selected.
A size error occurred in Tray 1.
A size error occurred in Tray 2.
There is no paper in Tray 1 and another tray cannot be selected.
There is no paper in Tray 2 and another tray cannot be selected.
The paper guides are in an unsupported position in the Bypass tray.
Tray 1 has not been inserted or the paper guides are in an unsupported position.
the paper guides.
Tray 2 has not been inserted or the paper guides are in an unsupported position.
the paper guides.
The paper specified for the job is not loaded into any of the trays.
job.
Attempted to select a tray automatically although all trays except the Tray 5
(bypass) are not selectable for auto selection.
Problem Solving
49