Replacing A Handset - VTech DS3111-2 User Manual

Installation

Replacing a handset

When you are replacing rather than adding a handset, for your handsets to be
• If the de-
numbered sequentially, you need to delete all the handset registrations on the
registration
telephone base, then register all handsets again.
process is not
successful, you
To de-register all handsets
may need to
reset the system
1.
and try again.
To reset: pick up
the registered
handset and press
/FLASH
the
2.
button, then press
the OFF/CLEAR
button and place
the handset back
into the telephone
3.
base. You may
also reset by
unplugging the
power from the
telephone base,
then plugging it
After deleting the registrations of all handsets, you will need
back in.
to individually register each handset with the telephone base
• You cannot
de-register the (see page 6 for registration instructions).
handset(s) if a
system telephone
is in use.
8
Press and hold FIND HANDSET on the telephone base for
about 10 seconds (until the IN USE light on the telephone
base turns on and starts to flash), then release the
FIND HANDSET button.
Immediately press and release FIND HANDSET again.
You must press FIND HANDSET while the IN USE light is
still flashing. The IN USE light will flash for approximately
seven seconds.
Soon, all handsets registered to the telephone base
will show CONNECTING... and it will take about 10
seconds to complete the de-registration process. All
handsets will show NOT REGISTERED if de-registration
is successful.
www.vtechphones.com
NOT REGISTERED