Telephone Base & Charger Installation - VTech DS3111-2 User Manual

Installation
Telephone base & charger installation
We recommend that you install the telephone base away from any electronic
• Use only the
equipment and appliances such as personal computers, computer routers,
VTech batteries
and power television sets, microwave ovens, and refrigerators. Avoid excessive heat, cold,
adapters supplied
dust or moisture. When a location is selected, install the telephone base and the
with this telephone.
charger as shown below. The telephone base is designed for desk or tabletop use
To obtain a
only. Make sure that the electrical outlet is not controlled by a wall switch.
replacement, visit
our website at
www.vtechphones.
com or call
1 (800) 595-9511.
In Canada, go to
www.vtechcanada.
com or call
DSL filter (not
1 (800) 267-7377.
included) required
• The power
if you have DSL
adapters are
high-speed
intended to be
Internet service
correctly oriented
in a vertical or floor
mount position.
The prongs are not
designed to hold
the plug in place
if it is plugged into
a ceiling or an
under-the-table/
cabinet outlet.
2
Telephone base power adapter
Telephone
wall jack
Telephone line cord
www.vtechphones.com
EQUIPMENT
TELEPHONE
ONLY SOURCE POWER 2 CLASS
300mA 6V DC
PHONE. THIS USING WHEN ENSURED BE NOT MAY COMMUNICATIONS
OF PRIVACY OPERATION. UNDESIRED CAUSE MAY THAT INTERFERENCE INCLUDING
RECEIVED, INTERFERENCE ANY ACCEPT MUST DEVICE THIS 2) AND INTERFERENCE;
HARMFUL CAUSE NOT MAY DEVICE THIS 1) CONDITIONS: TWO FOLLOWING THE
TO SUBJECT IS OPERATION RULES. FCC THE OF 15 PART WITH COMPLIES DEVICE THIS
EW780-5656-00 ID: FCC HAC
RJ11C/RJ11W JACK: USOC
0.1B EQUIVALENCE: RINGER
US:EW7W401B80-565600 NO.: REGISTRATION
68 PART CFR 47 WITH COMPLIES
CHINA IN MANUFACTURED
Charger adapter
Electrical outlet
not controlled by
a wall switch