Batteries; Battery Care And Maintenance; Replacing The Handset Battery - VTech t 2429 Manual

Hide thumbs Also See for t 2429:

Table of Contents

Batteries

• The battery needs charging when:

— A new battery is installed in the handset.

— The phone beeps twice every five seconds.

— The screen displays

• Place the handset in the base so the

typically fully charged in 15 hours.

• You can keep the battery fully charged by returning the handset to the base

after each use.

• If you repeatedly get a low battery indicator, even after charging overnight,

the battery should be replaced. Use only VTech batteries.

CAUTION: To reduce the risk of fire or injury to persons or damage to the

telephone, read and follow these instructions carefully:Charge the

battery provided with or identified for use with this product only in

accordance with the instructions and limitations specified in this user

manual.

1. Remove the battery compartment cover on the handset by pressing on the

indentation and sliding the cover downward.

2. Lift out the old battery and disconnect.

3. Align the two holes in the new battery's plug with the socket pins, and snap

the plug into place. Place the battery in the compartment with the wires in the

lower left corner, along the bottom of the battery.

4. Replace the cover by sliding it up into place.

5. The new battery must be charged before using the phone. Place the handset

in the base and allow it to charge for at least 24 hours the first charge. The

telephone might operate before that, but for best performance, let the battery

charge fully.

t 2429 Manual .pmd

and displays the low battery icon.

BATTERY LOW

CHARGING

light turns on. The battery is

12/10/2004, 4:30 PM

Table of Contents