Datavideo HS-1600T MKII Instruction Manual page 42

-
Push the Record and Stream buttons simultaneously while turning on the device's power.
-
Wait for about five seconds and release the button push as soon as you see the RECORD and
STREAM button LEDs light up.
 Reboot the PC.
If the problem persists, try the following:
 Temporarily shut down the anti-virus software or firewall.
 Make sure no other devices are connected to the LAN (wired or wireless) because this may result
in IP conflicts.
After trying all methods and if the problem is still not solved, the NVS-31 MARK II video streaming
server offers the fixed IP feature that allows you to establish direct connection to the NVS-31 MARK II.
The default IP address is 192.168.1.60.
This method allows you to configure the NVS device to the IP range of your network so that you do
not need a DHCP server to gain access to the NVS device.
 Connect your PC to the NVS device directly using an Ethernet cable (not necessarily a crossover
cable).
Next, change the network settings of your PC or laptop.
 Click START located at the bottom left corner of your screen.
 On the text bar, enter Network Connections then click the icon that appears.
 Double click the network adapter that connects your PC or laptop to the network.
 Click the "Properties" button.
 Select "Internet Protocol Version 4 (TCP/IPv4)" option and click the "Properties" button.
 Check the "Obtain an IP address automatically" option.
 Enter IPv4 settings:
-
IP Address: 192.168.1.2
-
Subnet Mask: 255.255.255.0 (System default is 255.255.255.0)
-
Default Gateway: Not required for one-to-one connection.
42