Note: Please write down the IPv4 address previously entered as it may be needed after you are
done with streaming or recording.
The NVS-31 MARK II should now be connected with an IP address of 192.168.1.60.
If the NVS-31 MARK II still cannot connect, simply restore the NVS-31 MARK II to the factory
defaults.
-
Turn off the device.
-
Push the Record and Stream buttons simultaneously while turning on the device's power.
-
Wait for about five seconds and release the button push as soon as you see the RECORD and
STREAM button LEDs light up.
-
Make sure no other devices are connected to the LAN (wired or wireless) because this may
result in IP conflicts.
Login the NVS-31 MARK II via a web browser.
-
Default user name is admin
-
Default password is 000000
Click the "System" tab then on the system page, enter network settings such as static IP and
default gateway. Make sure that the default gateway matches your connected network and no
device shares the same IP as the NVS-31 MARK II.
For example, if your router's default gateway IP is 10.10.1.1, then in the default gateway field, you
should also enter 10.10.1.1. Then set the IP address of the NVS-31 MARK II to 10.10.1.X, which can
range from 10.10.1.2 to 10.10.1.255. Pick an unused IP address.
43