Advertisement
STEP 52
If upon completion of assembl3:, the I~AD PLATE (72) does not
sit on top of the first WEIGHT PLATE (105), push the HEAD
PLATE (72) down, insert the WEIGHT STACK PIN (75)
peffom~ several repetitions at the press station. Tiffs ~511 relax the
cable system and prevent the HEAD PLATE (72) from lifting up.
If after completing previous step, the HEAD PLATE (72) still does
not sit on top of the first WEIGHT
PLATE (105) or if there
excess slack in the cable system, adjust the two threaded ends of
the HEAD PLATE CABLE (102) accordingly and retighten the jam
nuts.
If there is excess slack in the AB or PEC DEC cable ~'stem, adjust
the threaded end of the AB CABLE (103) accordingly and re-
tighten the jam nut.
FIGURE 52
FIGURE 53
STEP 53
¯ Apply pressure to the bottom of one SHROUD
(31) where thw "V" groove is and carefuly remove the weight stack opening on the plastic
SHROUD
(31) as shown m FI GUP,.E 53. Tiffs ~411 be the front SHROUD
(31).
¯ Apply one PARABODY
425,~'~I01155"F~.E£ LABEL (32) to the front SHROUD
(31) approximately 2" from the top as shown in FIGURE
53.
44
Advertisement
