Advertisement
FIGURE 35
STEP 35
¯ To assemble the D-RING CABLE (102)~foltow the Cable routing as shown and use the following steps:
, Screw one of ~e threaded ends of the D-RING CABLE
(102) approximately ~' into theend of the SELE CTOR SHAF
~ (7~) of the H EAD
PLATE (72) as shownin FIGURE 35,
, Route the CABLE (102) up and over the two PULLEYS in the TOP BOOM (17) above tile WEIGHT STACK. (Remove pulleys
|~r ease of installation.)
¯ Screw the other threaded end of the D-RING CABLE
(102) approximately I into the end of the shaft on the D-RING (7) as sho~n
FIGURE 35,
SECURELY
tighten two pulley connections from the previous step,
2
Advertisement
