Advertisement
¯ [ FIGURE 36
,NOTE: REMOVE BOLTS FOR
CABLE INSTALLATION
STEP 36
To assemble the LAT CABLE (99) follow the cable routing as shown and use the following steps:
¯ Remove the two bolts in the FRONT UPRIGHT (25) and TOP BOOM (17) connection.
¯ Route the LAT C;-MBLE (99) as shoxvn in FIGURE 33. (Remove pulle.vs for ease of installation.)
¯ Run the LAT CABLE (99) ttzrough one of the holes in the D-RING (7) and attach one KEYHOLE
CLEV~[S (66) to the end of the
CABLE (99). See FIGURE 36.
¯ Replace and SECURELY
tighen the FRONT UPRIGHT (25) and TOP BOOM (17) connection m:~y pulle ys from the p revi ous
step. (NOTE: Make sure the LAT CABLE runs over the top of the bolts in the top boom.)
33
Advertisement
