Advertisement
FIGURE 13
~/~
STEP 13
¯ SECURELY
assemble the SELECTOR SHAFT (73) to the HEAD PLATE (72) using one 3/8 X 1-1/4" BOLT (83) and one
WASHER (91 ).
¯ Insert four CAP PLUGS (55) into the top and bottom ends of the GUIDE RODS (36) as shownin FIGURE
¯ Insert ~vo GUIDE RODS (36) into the BASE (1) as shown onFIGURE 12. (NOTE: Lubricate GUIDE RODS (36) Mth silicon or
spray available at most hardware stores.)
¯ Slide two 1-1/4 SQ. X 4-7/8" TUBES (34), two 3/4" WASHERS
(71), and t~vo WEIGHT STACK CUSHIONS (70) - IN
ORDER - down over the GUIDE RODS (36).
¯ Using EXTRElVIE CARE slide all fifteen WEIGHT PLATES (105) down over the GUIDE RODS (36) on to the WEIGHT STACK
CUSHIONS
(70). Make sure that the keyholes of the WEIGHT PLATES (105) are all facing the right way. (NOTE: ff the359101
LB. ADD-KIT is purchased refer to the 359101 ASSEMBLY INSTRUCTIONS
no~:)
¯ Slide the head plate assembly timbal o~:er the GUIDE RODS (36) onto the weight stack.
¯ Attach the WEIGHT STACK LABELS (104) to the weight stack. Also insert the WEIGHT STACK PIN ~75) imo the first
WEIGHT PLATE (105) of the weight stack.
13
Advertisement
