ParaBody Serious Steel 425104 Assembly Instructions Manual page 23

Hide thumbs Also See for Serious Steel 425104:

STEP 23

~ PUSH/~ULL---~

t.... 1/4" NUTS

SPRING PIN

I)ONOT O~,~RTIGHTE~N!

ASSEMBLY

DETAIL 25

¯ SECURELY assemble the SPRING PIN ASSEMBLY of the PUSH/PULL CABLE to the SPRING PIN B..~RREL on the RECEIV-

ING TUBE (13).

(!!!

IMPORTANT !!! TIGHTEN THE NUT OF THE SPRING PIN ASSEMBLY SECURITY)

Swing the PRESS ARM (27) up until the SPRING PIN of the PUSH/PULL CABLE engages in one of the adjustment holes.

¯ Thread the second 1/4-28 IN. NUT onto the threaded end of the CABLE, and cinch the t~vo 1/4-28 IN. NUTS around the flat (IMPOR-

TAN'r! DO NOT OVER TIGttTEN NUTS!)

Use the extra thread on the end of the CABLE to adjust out slack. ( !H DO NOT ADJUST OUT TO FAR !!! ALWAYS

ALLOW

SPRING PIN ASSEMBLY TO FULLY ENGAGE)

3/8

FIGURE 26

STEP 26

¯ SECURELY

assemble the SF',AT PAD (40) to the

BACK PAD ADJUST (16) using four 3/8 X 1-1/4"

BOLTS (83) and four 3/8" WASHERS

(91).

FIGURE 26.

¯ SECURELY

assemble one 3/8:" SPRhNG PIN ASSElvl-

BLY (51) to the FRONT UPRIGHT (25) as shown

FI Gb~,E 26.

¯ Attach one 3-PRONG KNOB (61) the FRONT UPRIGHT

(25) as shown in FIGURE 26.

Insert the SEAT PAD (40) & BACK PAD ADJUST

(16) into the FRONT UPI~[GtfI" (25) while pulling

.on the SPRING PIN ASSEMBLY

(51) until it engages

in one of the adjustment holes. See FIGURE 26.

1/2

[

1/2

[

1/2