Table of Contents
Advertisement
Step 4.
Hook the securing clip over the riser adapter on the riser cage.
Figure 82. 7mm drive cage securing clip installation
Step 5.
Install the 7mm drive cage to the riser cage.
Figure 83. 7mm drive cage installation
a.
Align the left-side pin on the 7mm drive cage with the positioning slot on the securing clip, the
two holes on the side brackets of the 7mm drive cage with the two holes on the front of the
riser cage.
b.
Install the two screws to secure the 7mm drive cage in place
Step 6.
Connect any cables from the 7mm drive backplanes. See "7mm drives" on page 68.
Step 7.
Install the riser 2 assembly to the riser 2 slot on the system board. See "Install a riser 1/2 assembly"
on page 204.
After you finish
1. Install all the drives and fillers (if any) into the drive bays. See "Install a hot-swap drive" on page 197.
ThinkSystem SR665 Setup Guide
196
Advertisement
Table of Contents
