Table of Contents
Advertisement
Server model
Required rearwall brackets
A1 rearwall bracket on the left
Server model
The server requires no rearwall brackets:
with 4 x 3.5-
inch rear drives
Install an A1 rearwall bracket (left)
Use this information to install an A1 rearwall on the left of the rear chassis.
About this task
Attention:
• Read "Installation Guidelines" on page 134 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Bz2XIeLEfGcrLGm9TSY_yt
• Youku:
http://list.youku.com/albumlist/show/id_52339612.html
Procedure
Step 1.
Touch the static-protective package that contains the new riser card to any unpainted surface on
the outside of the server. Then, take the new riser card out of the package and place it on a static-
protective surface.
Step 2.
Install an A1 rearwall bracket.
ThinkSystem SR665 Setup Guide
180
B2 rearwall bracket on the
middle
Advertisement
Table of Contents
