Table of Contents
Advertisement
Install the 7mm drive backplanes
Use this information to install the 7mm drive backplanes.
About this task
Attention:
• Read "Installation Guidelines" on page 134 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Bz2XIeLEfGcrLGm9TSY_yt
• Youku:
http://list.youku.com/albumlist/show/id_52339612.html
Procedure
Step 1.
Touch the static-protective package that contains the new backplane to any unpainted surface on
the outside of the server. Then, take the new backplane out of the package and place it on a static-
protective surface.
Step 2.
Connect the cables to the backplanes. See "7mm drives" on page 68.
.
Chapter 4
Server hardware setup
175
Advertisement
Table of Contents
