Table of Contents
Advertisement
Procedure
Step 1.
Install the processors.
a.
Slide the processor carrier into the rail frame.
b.
Push the rail frame down until the blue latches lock into place.
c.
Close the force frame.
d.
Tighten the screws in the installation sequence shown on the force frame.
Note: Use an ESD safe screwdriver and set the maximum torque value to 14.0 ± 0.5 inch-
pounds.
Figure 57. Processor installation
Step 2.
Install the standard or performance heat sink.
Note: For a new heat sink, the thermal grease is pre-applied to the heat sink. Remove the
protective cover and install the heat sink.
a.
Orient the heat sink with the screw holes on the processor plate. The captive screws on the
heat sink should align with the screw holes on the processor plate.
b.
Tighten all the captive screws in the installation sequence shown on the heat-sink label.
c.
(Optional) Tighten the two screws located in the front of the performance heat sink.
Note: Use an ESD safe screwdriver and set the maximum torque value to 14.0 ± 0.5 inch-
pounds.
.
Chapter 4
Server hardware setup
161
Advertisement
Table of Contents
