Table of Contents
Advertisement
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Bz2XIeLEfGcrLGm9TSY_yt
• Youku:
http://list.youku.com/albumlist/show/id_52339612.html
Procedure
Step 1.
Prepare your server.
1. Install the required performance system fans. See "Install a system fan" on page 223.
2. Install the required riser brackets. See
• "Install a riser 1/2 assembly" on page 204
• "Install a riser 3 assembly" on page 208
3. Install the backplane to the drive cage. See "Install the middle or rear 2.5-inch-drive
backplane" on page 171.
4. Remove irrelevant rearwall brackets(if any) and install the rearwall bracket required for
installing 4 x 2.5-inch rear drive cage.
• The rearwall bracket combinations matrix in the "Rearwall bracket replacement" section in
Maintenance Manual.
• "Install a C1/C2 rearwall bracket (right)" on page 182
Step 2.
Install the 4 x 2.5-inch rear drive cage.
Figure 80. Installing the 4 x 2.5-inch rear drive cage
1. Align the rear drive cage with the chassis, and lower the drive cage into the chassis.
2. Move the rear drive cage forward until it clicks into position.
Step 3.
Check and ensure that the plunger is latched into place to secure the rear drive cage.
After you finish
1. Reinstall the drives or drive fillers into the rear drive cage. See "Install a hot-swap drive" on page 197.
ThinkSystem SR665 Setup Guide
192
Advertisement
Table of Contents
