Table of Contents
Advertisement
About this task
Your server supports:
• One type of middle 3.5-inch-drive backplane
– 4 x 3.5-inch SAS/SATA backplane
• Two types of rear 3.5-inch-drive backplane
– 2 x 3.5-inch SAS/SATA backplane
– 4 x 3.5-inch SAS/SATA backplane
Notes:
• The procedure shows the installation of the backplane on the rear drive cage. The procedure is the same
for installing the backplane on the middle drive cage.
Attention:
• Read "Installation Guidelines" on page 134 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Bz2XIeLEfGcrLGm9TSY_yt
• Youku:
http://list.youku.com/albumlist/show/id_52339612.html
Procedure
Step 1.
Touch the static-protective package that contains the new backplane to any unpainted surface on
the outside of the server. Then, take the new backplane out of the package and place it on a static-
protective surface.
Step 2.
Connect the cables to the backplane.
Step 3.
Align the bottom of the backplane with the studs at the bottom of the drive cage. Rotate the
backplane to vertical position so that the holes in the backplane pass through the pins on the drive
cage, and press the backplane into position. The release latches will secure the backplane in place.
.
Chapter 4
Server hardware setup
173
Advertisement
Table of Contents
