Table of Contents
Advertisement
About this task
Attention:
• Read "Installation Guidelines" on page 134 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Bz2XIeLEfGcrLGm9TSY_yt
• Youku:
http://list.youku.com/albumlist/show/id_52339612.html
Procedure
Step 1.
Touch the static-protective package that contains the new riser card to any unpainted surface on
the outside of the server. Then, take the new riser card out of the package and place it on a static-
protective surface.
Step 2.
Install a C1 rearwall bracket.
Note: The illustration shows removing a C1 rearwall bracket. The procedure is the same for
removing the C2 rearwall bracket.
Figure 73. C1 rearwall bracket installation
a.
Align the pin on the rearwall bracket and the pin slot on the right side of the rear chassis. Install
the bracket to the chassis as shown.
b.
Install the four screws to secure the rearwall bracket.
After you finish
Install a rear drive cage or riser assemblies. See
• "Install the 4 x 2.5-inch rear drive cage" on page 191
• "Install a riser 1/2 assembly" on page 204
.
Chapter 4
Server hardware setup
183
Advertisement
Table of Contents
