Technical Reference - ZyXEL Communications EX5501-B0 User Manual

Table 19 Network Setting > Broadband > Cellular Backup (continued)
LABEL
Data Budget
% of time
budget/data
budget
(Mbytes)/data
budget
(kPackets)
Actions when
over budget
Current Cellular
connection
Actions
Enable E-mail
Notification
Mail
Account
Cellular
Backup E-
mail Title
Send
Notification
to Email
Interval
Enable Log
Cancel
Apply

6.4 Technical Reference

The following section contains additional technical information about the Zyxel Device features
described in this chapter.
Encapsulation
Be sure to use the encapsulation method required by your ISP. The Zyxel Device can work in bridge
mode or routing mode. When the Zyxel Device is in routing mode, it supports the following methods.
IP over Ethernet
IP over Ethernet (IPoE) is an alternative to PPPoE. IP packets are being delivered across an Ethernet
network, without using PPP encapsulation. They are routed between the Ethernet interface and the
WAN interface and then formatted so that they can be understood in a bridged environment. For
instance, it encapsulates routed Ethernet frames into bridged Ethernet cells.
Chapter 6 Broadband
DESCRIPTION
Select the check boxes and enter a number from 1 to 99 in the percentage fields. If you change
the value after you configure and enable budget control, the Zyxel Device resets the statistics.
Specify the actions the Zyxel Device takes when the time or data limit is exceeded.
Select Keep to maintain an existing cellular connection or Drop to disconnect it.
Click this switch to enable or disable the e-mail notification function. When the switch goes to
the right , the function is enabled. Otherwise, it is not.
The Zyxel Device will e-mail you a notification whenever over budget occurs.
Select an e-mail address you have configured in Maintenance > E-mail Notification. The Zyxel
Device uses the corresponding mail server to send notifications.
You must have configured a mail server already in the Maintenance > E-mail Notification screen.
Type a title that you want to be in the subject line of the e-mail notifications that the Zyxel Device
sends.
Notifications are sent to the email address specified in this field. If this field is left blank,
notifications cannot be sent via email.
Enter the interval of how many minutes you want the Zyxel Device to e-mail you.
Select this to activate the logging function at the interval you set in this field.
Click Cancel to discard any changes to the settings.
Click Apply to save your changes.
EX5501-B0 / AX7501-B0 / PX7501-B0 User's Guide
91