ZyXEL Communications EX5501-B0 User Manual page 138

Click Network Setting > Home Networking > Additional Subnet to display the screen shown next.
Figure 77 Network Setting > Home Networking > Additional Subnet
The following table describes the labels in this screen.
Table 36 Network Setting > Home Networking > Additional Subnet
LABEL DESCRIPTION
IP Alias Setup
Group Name Select the interface group name for which you want to configure the IP alias settings. See
Chapter 15 on page 198
Active Click this switch to configure a LAN network for the Zyxel Device. When the switch goes to the
right
IPv4 Address Enter the IP address of your Zyxel Device in dotted decimal notation.
Subnet Mask Your Zyxel Device will automatically calculate the subnet mask based on the IPv4 address that
you assign. Unless you are implementing subnetting, use this value computed by the Zyxel
Device.
Public LAN
Active Click this switch to enable or disable the Public LAN feature. When the switch goes to the right
, the function is enabled. Otherwise, it is not.
Your ISP must support Public LAN and static IP.
IPv4 Address Enter the public IP address provided by your ISP.
Subnet Mask Enter the public IPv4 subnet mask provided by your ISP.
Offer Public IP Click this switch to enable or disable the Zyxel Device to provide public IP addresses by DHCP
by DHCP server. When the switch goes to the right
Enable ARP Click this switch to enable or disable the ARP (Address Resolution Protocol) proxy. When the
Proxy switch goes to the right
Cancel Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
EX5501-B0 / AX7501-B0 / PX7501-B0 User's Guide
Chapter 8 Home Networking
for how to create a new interface group.
, the following fields will be configurable. Otherwise, they are not.
, the function is enabled. Otherwise, it is not.
138
, the function is enabled. Otherwise, it is not.