ZyXEL Communications EX5501-B0 User Manual page 34

Table 5 Configuration Menus Summary (continued)
LINK TAB
WLAN Station WLAN Station
Status
Status
Cellular Cellular Statistics
Statistics
GPON Status GPON Status
Maintenance
System System
User Account User Account
Remote MGMT Services
Management
Trust Domain
SNMP SNMP
Time Time
E-mail E-mail
Notification
Notification
Log Settings Log Setting
Firmware Firmware
Upgrade
Upgrade
Backup/Restore Backup/Restore
Reboot Reboot
Diagnostic Diagnostic
Ping&Traceroute
&Nslookup
802.1ag
802.3ah
EX5501-B0 / AX7501-B0 / PX7501-B0 User's Guide
Chapter 2 The Web Configurator
FUNCTION
Use this screen to view the wireless stations that are currently associated
with the Zyxel Device.
Use this screen to look at the cellular Internet connection status.
Use this screen to view the fiber optical transceiver's TX power and RX
power level and its temperature.
Note: Not yet available as of this writing.
Use this screen to set Device name and Domain name.
Use this screen to change user password on the Zyxel Device.
Use this screen to enable specific traffic directions for network services.
Use this screen to view a list of public IP addresses which are allowed to
access the Zyxel Device through the services configured in the
Maintenance > Remote Management > MGMT Services screen.
Use this screen to configure SNMP (Simple Network Management
Protocol) settings.
Use this screen to change your Zyxel Device's time and date.
Use this screen to configure up to two mail servers and sender addresses
on the Zyxel Device.
Use this screen to change your Zyxel Device's log settings.
Use this screen to upload firmware to your Zyxel Device.
Use this screen to backup and restore your Zyxel Device's configuration
(settings) or reset the factory default settings.
Use this screen to reboot the Zyxel Device without turning the power off.
Use this screen to identify problems with the Zyxel Device. You can use
Ping, TraceRoute, or Nslookup to help you identify problems.
Use this screen to identify problems with the Zyxel Device. You can use
Ping, TraceRoute, or Nslookup to help you identify problems.
Use this screen to configure CFM (Connectivity Fault Management) MD
(maintenance domain) and MA (maintenance association), perform
connectivity tests and view test reports.
Use this screen to configure link OAM port parameters,
34