Tachometer; Fuel Gauge - Subaru Impreza 2016 Manual

3-12
Instruments and controls/Meters and gauges
Also, if you open and close the driver s
door within 10 seconds of illumination of
the odometer/trip meter, the odometer/trip
meter will turn off.
The display can be switched as shown in
the following sequence by pressing the
trip knob.
1
* : They cannot be displayed when the
ignition switch is in the ON position.
2
* : MT models without gear shift indicator
only
To set the trip meter to zero, select the A
trip or B trip meter by pressing the knob
and keep the knob pressed for more than
2 seconds.
CAUTION
To ensure safety, do not attempt to
change the function of the indicator
during driving, as an accident could
result.
NOTE
If the connection between the combina-
tion meter and battery is broken for any
reason such as vehicle maintenance or
fuse replacement, the data recorded on
the trip meter will be lost.
& Tachometer
The tachometer shows the engine speed
in thousands of revolutions per minute.
CAUTION
Do not operate the engine with the
pointer of the tachometer in the red
zone. In this range, fuel injection will
be cut by the engine control module
to protect the engine from overrev-
ving. The engine will resume run-
ning normally after the engine speed
is reduced below the red zone.
NOTE
To protect the engine/transmission
while the select lever is in the "P" or
"N" position (for CVT models) or the
shift lever is in the neutral position (for
MT models), the engine is controlled so
that the engine speed may not become
too high even if the accelerator pedal is
pressed hard.
& Fuel gauge
CAUTION
For diesel engine models, fill the
tank with diesel fuel. For details
about diesel fuel, refer to "Fuel
requirements for diesel engine mod-
els" F7-3.
Fuel gauge (type A)
1) Trip knob (left-hand drive models)
2) Trip knob (right-hand drive models)