Automatic Climate Control Operation (Type B, C And D); Type B; Type C And D - Subaru Impreza 2016 Manual

Automatic climate control
operation (type B, C and D)
When this mode is selected, the fan
speed, airflow distribution, air-inlet control,
and air conditioner compressor operation
are automatically controlled. To activate
this mode, perform the following.
NOTE
. Even when cooling is not necessary,
setting the temperature much lower
than the current outlet air temperature
turns on the air conditioner compres-
sor automatically and the "A/C" indi-
cator light on the control panel illumi-
nates.
. The air conditioner may not operate
in the following cases:
– when the cabin temperature is
low
– when the ambient temperature
decreases close to 08C (328F)
. The controllable temperature range
may vary depending on the regional
specifications of the vehicle.
& Type B
1. Turn the airflow mode selection dial
and fan speed control dial to the AUTO
position.
Climate control/Automatic climate control operation (type B, C and D)
2. Set the preferred temperature using
the temperature control dial.
NOTE
Each function can be individually set to
the AUTO mode independently of the
other functions. Any function set to the
AUTO mode is controlled automati-
cally. Any function not set to the AUTO
mode can be manually adjusted as
desired.
To turn off the climate control system, turn
the fan speed control dial to the OFF
position. Then the air inlet selection will be
set as follows.
. when the AUTO mode is selected: OFF
(outside air)
. when the AUTO mode is not selected:
the mode that was selected when turning
off the climate system will be selected.
& Type C and D
1. Press the AUTO button. The indica-
tor light FULL AUTO on the display
illuminates.
2. Set the preferred temperature using
the temperature control dial.
NOTE
If you operate any of the buttons on the
control panel other than the "OFF"
button, rear window defogger button
and temperature control dial(s) during
FULL AUTO mode operation, the
"FULL" indicator light on the control
panel will turn off and the "AUTO"
indicator light will remain illuminated.
You can then manually control the
system as desired using the button
you operated. To change the system
back to the FULL AUTO mode, press
the "AUTO" button.
To turn off the climate control system,
press the OFF button. Then the air inlet
selection will be set to OFF (outside air).
– CONTINUED –
4-7