Subaru Impreza 2016 Manual page 365

erator pedal and turn the ignition
switch to the START position. If the
engine starts, quickly release the
accelerator pedal.
(3) If this fails to start the engine, turn
the ignition switch again to the LOCK
position. After waiting for 10 seconds
or longer, turn the ignition switch to the
START position without depressing
the accelerator pedal.
(4) If the engine still does not start, we
recommend that you contact your
nearest SUBARU dealer for assis-
tance.
6. Confirm that all warning and indicator
lights have turned off after the engine has
started. The fuel injection system auto-
matically lowers the idle speed as the
engine warms up.
! MT diesel engine models
1. Apply the parking brake.
2. Turn off unnecessary lights and ac-
cessories.
3. Depress the clutch pedal to the floor
and shift the shift lever into neutral. Hold
the clutch pedal to the floor while starting
the engine.
Starting and operating/Starting and stopping engine (models without push–button start system)
Preheating indicator light (type A)
Preheating indicator light (type B)
4. Turn the ignition switch to the ON
position and check the operation of the
warning and indicator lights. At this time,
confirm that the preheating indicator light
has illuminated for a few seconds and has
turned off. Refer to Warning and indicator
lights F3-14.
5. Turn the ignition switch to the START
position without depressing the accelera-
tor pedal. Release the key immediately
after the engine has started.
6. Confirm that all warning and indicator
lights have turned off after the engine has
started. The fuel injection system auto-
matically lowers the idle speed as the
engine warms up.
NOTE
You may feel vibration during engine
idling for several tens of seconds. This
vibration is caused by a self-learning
procedure of the injector. This learning
procedure is necessary to stabilize the
best engine performance. Therefore, it
does not indicate a malfunction.
! CVT models
1. Apply the parking brake.
2. Turn off unnecessary lights and ac-
cessories.
3. Shift the select lever to the P or N
position (preferably P position).
4. Turn the ignition switch to the ON
position and check the operation of the
warning and indicator lights. Refer to
– CONTINUED –
7-9